（1） If the pump matches the pressure of your oil circuit, there is generally no need to debug it.

（2） Hydraulic oil circuits usually have a relief valve at the beginning to prevent excessive pressure from damaging the valve and other components for maintenance purposes. Usually, adjust this first. The numerical value is lower than the high working pressure of your hydraulic components, just increase the required pressure.

（3） Adjust the pressure of each circuit. A pressure relief valve or something. Just gradually adjust the pressure according to the needs. If you use a proportional valve, it adjusts the speed of the oil cylinder inlet and outlet. Can be adjusted based on output power.

In fact, there is no consistent adjustment method for hydraulic stations, and it also depends on whether there is any impact between the various branches. If it is controlled by PLC, it also needs to be adjusted in conjunction with the program, which will have a better effect. However, in the process of operation, if a small energy-saving hydraulic station is operated improperly, it can cause damage to the mold and even lead to accidents. Therefore, when operating the equipment, it is necessary to strictly follow the operating procedures to avoid harm.

(1) If the operator of the hydraulic station is a qualified operator after training, two people should perform the operation simultaneously, one person should be responsible for sequential command and the other person should be responsible for detailed operation. To ensure the correctness of the performance, the operator should loudly repeat the command of the operator before operating, and the operator should not respond when hearing the correct response. Otherwise, it should be corrected in a timely manner;

(2) Before operation, check that the screws for demolding/closing have been removed, the hydraulic pipelines have been properly connected, and the circuit breakers of each electrical unit are in a closed state;

(3) Reset the emergency stop button and start the hydraulic station;

(4) Perform demolding/closing operations;

(5) Press the emergency stop button after completing the operation;

(6) Closed main power supply.

Article source: Jiangmen Hydraulic Component Manufacturer http://www.jh-hydraulic.com